Low Poly TIE Fighter

A physical Low Poly TIE Fighter model, colour-printed in PLA and hand-assembled in Sydney. This stylised Star Wars display piece uses deliberate flat facets rather than a screen-accurate smooth finish and is AU$69.95.

Ships as one configuration, ready to display.

Questions

Why low-poly?
It is a stylised interpretation, not a screen replica. If you want accuracy over style, this is not the one.

Does it come with a stand?
It ships as shown in the photos.

Is it coloured?
Yes. The colour is printed into the model using multi-colour 3D printing — each colour is laid down in place as it prints, not painted on afterwards, so it cannot chip or flake.

How big is it?
Check the photos for scale — it is a desk-sized piece.

Do the wings detach?
No, it is supplied assembled.

Is this a finished Low Poly TIE Fighter model or a digital STL?
It is a physical, fully assembled display model — not a digital download.

How it's made

Printed in PLA at a fine layer height, then hand-assembled and sanded back where needed. Made and finished in Sydney, Australia.

An honest note: this is FDM printing. Fine layer lines are visible up close — that is how the process works, not a defect.

Fan-made display model. Not affiliated with or endorsed by the rights holders of Star Wars.

Tracked shipping from Sydney, Australia. Most orders leave the studio within 3–5 business days. International delivery typically takes 7–20 business days depending on destination.

3D printed in PLA. Keep out of direct sunlight and away from heat sources such as car dashboards. Dust with a soft dry brush. Intended for display only — not a toy.