Dolphin Phaser with Stand

A physical Dolphin Phaser replica with display stand from Star Trek: Nemesis. Colour-printed in PLA and hand-assembled in Sydney, this curved Type II phaser is named for its profile.

Dark Gray as Photos is the finish shown; Light Gray is the same part in a paler body. Same price either way.

Questions

Is the display stand included with the Dolphin Phaser replica?
Yes, the stand is included in both colour options.

Does it light up?
No — display and cosplay prop, no electronics.

Which grey should I pick?
Dark Gray matches the photos. Light Gray is the same part, lighter.

Is it coloured?
Yes. The colour is printed into the model using multi-colour 3D printing — each colour is laid down in place as it prints, not painted on afterwards, so it cannot chip or flake.

Does it come with a holster?
No holster on this one. The Lower Decks Phaser with Stand and Holster and the First Contact Boomerang Phaser with Stand have holster options.

How it's made

Printed in multi-colour PLA at a fine layer height, then hand-assembled and sanded back where needed. The colours are printed into the material rather than painted on, so the panel graphics and trim cannot chip or flake. Made and finished in Sydney, Australia.

An honest note: this is FDM printing. Fine layer lines are visible up close — that is how the process works, not a defect. It is a display and cosplay prop: nothing lights up, opens electronically or functions.

Fan-made display prop. Not affiliated with or endorsed by the rights holders of Star Trek.

Tracked shipping from Sydney, Australia. Most orders leave the studio within 3–5 business days. International delivery typically takes 7–20 business days depending on destination.

3D printed in PLA. Keep out of direct sunlight and away from heat sources such as car dashboards. Dust with a soft dry brush. Intended for display only — not a toy.